170KW Vacuum Tube Cookware Bottom Brazing Machine

TENYES 170KW Vacuum Tube Cookware Bottom Brazing Machine is mainly including high-frequency power supply, it also includes three-phase AC voltage regulating system, step-up transformer, high-voltage rectifier, filament regulator, electron tube, resonant capacitor, left and right switching knife switch, groove capacitor, inductor (large module head) and other parts. Mechanical rotation mechanism: it also includes three-phase AC asynchronous motor, reducer, indexer and turntable.Hydraulic lifting mechanism: including hydraulic station (including motor, hydraulic pump, solenoid valve, etc.), hydraulic cylinder.

Send Inquiry

Product Description

The 170KW Vacuum Tube Cookware Bottom Brazing Machine with the multiplayer and compound base mainly is employed in the welding of the compound base of the tableware such as stainless steel pan, pot and kettle, etc., as well as in the plane heating of other work-piece. It is the high-tech production of integration of machine, liquid and electricity controlled by many sets of microcomputers, whose performance takes the leading position in China.

Model description: (Taking 170KW as an example)

GPQH-21-170/500 type

GP: High frequency

QH: Brazing

21: Single head dual station

170: Maximum power 150KW

Input power supply: three-phase power frequency 380V ± 10%, 50Hz.

Rated output: oscillation power 150KW, frequency 200KHZ.

Environmental requirements for use:

This device is allowed for long-term use under the following conditions:

Altitude not exceeding 1000 meters;

Environmental temperature -5 ℃ -+40 ℃;

The relative humidity of the air shall not exceed 85%;

No conductive explosive dust, no gases or vapors that corrode metals or damage insulation;

No severe vibration or impact;

The fluctuation range of AC power supply voltage amplitude shall not exceed ± 10%.

Cooling water: The pH value of primary cooling water is within the range of 6.5-8.5, with a hardness not exceeding 60mg/l and a resistivity greater than 10kg/cm3. The secondary cooling water is softened water or purified water

The inlet water temperature of the cooling water in the heat exchanger is below 30 degrees, and the flow rate is greater than 2 liters per second.